I just uprgraded to CS4 from CS3 and there's a problem with the brushes that I can't seem to figure out. I have the brush set to pen pressure, and at the end of each stroke, there's a dot. Like this:
/Users/jpb1343/Desktop/Picture 13.png
I thought it may have been my drawing tablet, but CS3 worked fine. Is there anything I can do to make the brush strokes smooth?
#1
jennifer,
Your link is incomplete.
What device are you using to draw? Did you check for later driver software for it?
Neil
#2
jennifer,
Your link is incomplete.
What device are you using to draw? Did you check for later driver software for it? And your system specs would help as well.
Thanks.
Neil
#3
Looks like that link leads to the OP's computer. :D
#4
My hunch as well...
Jennifer, use the free pixentral.com to link a screenshot or other image.
Neil
#5
Sorry. Does this work?
#6
jennifer,
Have you asked Hanvon? (Most of the folks here use Wacoms for tablets).
Neil
#7
Also, have you looked for updated Wacom drivers?
#8
Jennifer,
I quickly checked the Hanvon site, and found no driver updates since 2007. However, here is there tech support page: <
http://usa.hanvon.com/Technical_Support/Default.shtml>
Neil
#9
Jennifer,
I quickly checked the Hanvon site, and found no driver updates since 2007. However, here is their tech support page: <
http://usa.hanvon.com/Technical_Support/Default.shtml>
Neil
#10
Thank you! I'll ask Hanvon about it.
#11