Thanks for the feedback. Yes, I did shoot in raw, so I could try some fringe cleanup in the raw imaging tool. The coloring doesn't look like the bi-color fringes I sometimes see. The color in the dark area is only blue.

I did think PS was simplifying its display when moving, although it's hard to see any degradation of the image after stopping the movement but still holding the button down. About the only change I notice is the loss of blue sky bleeding into the dark rust color. As you stop moving the picture and new areas of rusted cable are revealed, the detail and color in the newly visible rusted area is outstanding. The color of the cable in the area that had been in the original view and is still visible after the move still shows the blue bleed. When you release the button the blue bleed returns to the entire cable in the view. It seems that Adobe made a great clean-up tool algorithm without perhaps realizing it.

--
Best Regards,
Mike

http://photoshow.comcast.net/mikenoel

"Hunt" wrote in message

In article ,
says...

Hi. I'm not changing the zoom when I see the change, just grabbing the picture with the 'hand' tool to move the view around.

--
Best Regards,
Mike

http://photoshow.comcast.net/mikenoel

"KatWoman" wrote in message

"Mike Noel" wrote in message

In a particular picture in Photoshop document format taken with a digital
rebel xt and displayed on PS CS2, there is a narrow rusted cable in the distance against the blue sky. The blue of the sky appears to bleed into
the dark color of the backlit cable. When I grab the picture to move it
around, the blue bleed disappears and the cable takes on the correct dark
rusty color. When I stop moving the picture around, the blue bleed from
the sky appears again.
This makes me think the camera actually recorded the correct color information for the cable, but Photoshop is mishandling the information when it displays the picture in normal mode, but displays the information
correctly when it is displayed for the photo movement function. Can anyone explain what is going on?

--
Best Regards,
Mike

http://photoshow.comcast.net/mikenoel
when you zoom in it looks correct??
if so it is a monitor display problem
try higher resolution setting or better refresh rate??

Mike,

During the Drag action, the image is actually shown at a lower resolution, so
you are not likely to see the problem at that time. When you have positioned
it, PS goes to the set rez for the monitor.

The same thing happens, when you're using one of the Transform Tools, while,
say Scaling, the image goes to a lower rez, until you release the handle(s).
I've had it stick at the lower rez, until I double-click or Enter, but that is
not often, and was probably on some of my slower/smaller VRAM vid cards. Do
not recall seeing that happen for some time now.

Had the image been shot RAW, you could possibly clean it up easily with the
Color Fringing Tools in ARC. If you shot JPG, then a bit more manual work might be required. The color fringing is a result of one, or more, of several
factors, the lens, the sensor in the camera, JPG compression, sharpening in
camera, and the lighting.

Hunt

Mike Noel

Replied in the following topics

photoshop file display observation/question