Views
695
Replies
0
Status
Closed
In ImageReady I’ve been successful at slicing and creating rollovers using layers, but I have a problem I haven’t seen addressed in the newsgroups.
In addition to specifying which layers are visible during the rollover of each area, I need to also specify which layers overlap others. I’ve tried simply adjusting the sequence of layers in the Layers palette for each of the rollovers at the same time as I turn their layers on and off, and in the browser the on/off behavior is fine, but the layer overlaps don’t change when a new area is rolled over; they’re just whatever the last sequence was that I specified in the Layers palette.
Is it possible to make layer overlaps specific to rollover areas, or is only layer visibility specifiable?
In addition to specifying which layers are visible during the rollover of each area, I need to also specify which layers overlap others. I’ve tried simply adjusting the sequence of layers in the Layers palette for each of the rollovers at the same time as I turn their layers on and off, and in the browser the on/off behavior is fine, but the layer overlaps don’t change when a new area is rolled over; they’re just whatever the last sequence was that I specified in the Layers palette.
Is it possible to make layer overlaps specific to rollover areas, or is only layer visibility specifiable?
MacBook Pro 16” Mockups 🔥
– in 4 materials (clay versions included)
– 12 scenes
– 48 MacBook Pro 16″ mockups
– 6000 x 4500 px