Views
1034
Replies
0
Status
Closed
How do I manually callibrate my b/w LaserJet 1010? That is, can that be done?
BTW, the printer doesn’t support printing callibration bars (?!), so I’ve printed them from InDy with CM turned off. Now what? Is there a (fairly) accurate way of setting dot gain values? Any tips? I can do it manually by comparing the printed image to the screen image, but I’m sorta not getting the results I want…
Also, if there are sites where I can get the profile I need, I’d appreciate the info.
TIA
Branko
BTW, the printer doesn’t support printing callibration bars (?!), so I’ve printed them from InDy with CM turned off. Now what? Is there a (fairly) accurate way of setting dot gain values? Any tips? I can do it manually by comparing the printed image to the screen image, but I’m sorta not getting the results I want…
Also, if there are sites where I can get the profile I need, I’d appreciate the info.
TIA
Branko
MacBook Pro 16” Mockups 🔥
– in 4 materials (clay versions included)
– 12 scenes
– 48 MacBook Pro 16″ mockups
– 6000 x 4500 px